SATADOM Flashdisks
SATADOM Flashdisks SATA Disk-on-Module Flashdisk Solid-State Storage - up to 256GB capacity! Install an MLC or SLC SATADOM Flashdisk module onto any of our Aries or Helix single board computers for rugged, lightweight, solid-state mass storage. The flashdisk module works just like a SATA disk drive and requires no drivers. It provides high-speed nonvolatile mass storage in capacities of 32GB to 256GB. The flashdisk mounts on a SATA disk-on-module connector and is held in place with two spacers and screws (included). It operates over −40ºC to +85ºC. SATADOM flashdisk features: SATA compatible interface Single-level cell (SLC) flash modules for faster transfer speeds, lower power consumption, and higher cell endurance Multi-level cell (MLC) flash modules for lower cost and higher storage density Burst read/write of 300MB/s Sustained read performance of up to 165MB/s (SLC), 155MB/s (MLC) Sustained write performance of up to 150MB/s (SLC), 80MB/s (MLC) Static wear-leveling scheme with dynamic block allocation increases life and optimizes performance Built-in hardware ECC enables up to 16/24 bit correction per 1K bytes Flash bad-block management Self-Monitoring, Analysis and Reporting Technology (SMART) Power failure management ATA secure erase TRIM enabled for improved performance Supports boot function for Windows Embedded Standard 7, Windows Embedded CE, and Linux Low power consumption: MLC typical 475mA when active and 135mA in sleep mode SLC typical 330mA when active and 95mA in sleep mode Dimensions: 40.0×30.0×9.0mm -40ºC to +85ºC operation RoHS compliant
mSATA Flashdisk
mSATA Flashdisk mSATA Flashdisk Solid-State Storage - up to 512GB capacity! Install a MLC or SLC mSATA flashdisk module onto any of our Atlas or Hercules III single board computers for rugged, lightweight, solid-state mass storage. The flashdisk module works just like a SATA disk drive and requires no drivers. It provides high-speed nonvolatile mass storage in capacities of 8GB to 512GB. The flashdisk mounts on a mSATA connector and is held in place with two spacers and screws (included). It operates over −40°C to +85°C. mSATA flashdisk features: SATA compatible interface Single-level cell (SLC) flash modules for faster transfer speeds, lower power consumption, and higher cell endurance Multi-level cell (MLC) flash modules for lower cost and higher storage density Burst read/write of 300MB/s Sustained read performance of up to 165MB/s (SLC), 155MB/s (MLC) Sustained write performance of up to 150MB/s (SLC), 80MB/s (MLC) Static wear-leveling scheme with dynamic block allocation increases life and optimizes performance Built-in hardware ECC enables up to 16/24 bit correction per 1K bytes Flash bad-block management Self-Monitoring, Analysis and Reporting Technology (SMART) Power failure management ATA secure erase TRIM enabled for improved performance Supports boot function for Windows Embedded Standard 7, Windows Embedded CE, and Linux Low power consumption: MLC typical 475mA when active and 135mA in sleep mode SLC typical 330mA when active and 95mA in sleep mode Dimensions: 50.8×29.85×6.0mm -40°C to +85°C operation RoHS compliant
ACC-HDDMOUNT
ACC-HDDMOUNT PC/104 Hard Drive Mounting Board ACC-HDDMOUNT provides a convenient way to mount a 2.5" notebook hard drive directly onto a PC/104 stack in either the top or bottom position. Holes on the board enable the PC/104 connectors to pass through unaffected, so the board can be installed at the bottom of the stack closer to the lower board. Mounting spacers and screws for both the hard drive and the board are included, along with a 44-pin ribbon cable. The holes at the top of the board provide a small prototype area for customer circuitry. These are not designed to enable the installation or pass-through of a PC/104+ connector. The size of a 2.5" hard drive is too large to accommodate both the ISA and PCI connectors on a PC/104 size board.
Flashdisk
Flashdisk Flashdisk Solid-State Storage Install an IDE flashdisk module onto any of our CPU boards for rugged, lightweight, solid-state mass storage. The flashdisk module works just like an IDE drive and requires no drivers. It provides high-speed nonvolatile mass storage in capacities of 128MB to 4GB. The flashdisk mounts on the IDE connector and is held in place with a spacer and screws (included). It includes a master/slave jumper and operates over -40...+85ºC. IDE Flashdisk Programming Board ACC-IDEEXT accessory board lets you connect an IDE flashdisk and an IDE drive (hard disk or CD-ROM), or two IDE drives, to your Diamond Systems’ single board computer. You can also use it to load files from your desktop computer onto an IDE flashdisk module prior to installing the flashdisk onto the SBC. The ACC-IDEEXT board includes 40-pin and 44-pin mating connectors for compatibility with almost any computer and IDE device. 40-pin and 44-pin ribbon cables are included.
SSD-104 SATA 2.5”
SSD-104 SATA 2.5” SATA 2.5” Drive Carrier Connect Tech’s SSD/104 SATA 2.5″ Drive Carrier is a complete rugged stackable storage solution that allows any 2.5″ SATA hard drive to be installed into any Type II PCIe/104 stack or embedded system. The SSD/104 SATA 2.5″ Drive Carrier expands storage capacity and reduces overall storage footprint in an embedded system. Designed to be used with any 2.5″ SATA drive, the SSD/104 SATA 2.5″ Drive Carrier can be used with the latest SATA III SSD’s for high performance applications or other high capacity drives.
SSD/104 SATA
SSD/104 SATA Complete rugged stackable SSD and storage solution Connect Tech’s SSD/104 SATA is a complete rugged stackable solid state drive (SSD) and storage solution that allows up to two mSATA SSD modules to be installed into any PC/104-Plus, PCI-104, PCI/104-Express and PCIe/104 stack or embedded system. SSD/104 SATA solid state drive (SSD) and storage solution improves performance, expands storage capacity and reduces overall storage footprint in an embedded system. Designed with the latest generation of mSATA SSD modules, SSD/104 SATA solid state drive (SSD) and storage solution can be easily upgraded to accommodate future generations of mSATA modules for even greater system capacity and performance. When combined with mSATA SSD modules, SSD/104 SATA solid state storage solution directly interfaces with the standard SATA bus, which can be used as a drop-in replacement for any SATA storage device. SSD/104 SATA can also be interfaced with any single board computer or embedded system using standard 7-pin SATA. SSD/104 SATA is available as a complete storage solution with a preinstalled mSATA module, or as a separate mSATA carrier which supports any mSATA SSD module.
DA104
DA104 Hard Drive and Compact Flash adapters for PC/104 stacks The DA104 provides a convenient means of integrating a 2.5″ IDE hard drive, M‑Systems CompactFlash, or M‑Systems IDE2000 Flash Disk onto a PC/104 «stack». Connection of the drive to the host CPU IDE port is supported by a standard 40 pins ribbon cable. The 5VDC power for the drives is supplied either though the PC/104 bus, or 2 positions screw terminal. For additional memory, a second 2.5″ hard drive or IDE2000 Flash Disk can be mounted to the underside of the module.
MX200
MX200 Solid State Drive When the Crucial MX100 was released, it set a new standard for SSDs that the Crucial MX200 pushes even further. Leveraging leading specs on all fronts, along with new Dynamic Write Acceleration technology, the Crucial MX200 is loaded with innovative features and immediately increases your system's performance. The Crucial MX200 delivers 550 MB/s sequential reads on both compressible and incompressible data, and outperforms a typical hard drive by 400 MB/s. Even better, the performance doesn't let up, as the Crucial MX200 posts an endurance rating that's up to 5 times greater than a typical client SSD. Competing SSDs typically rely on a fixed cache of multi-level cell flash memory, which allows you to write sequential data at published specs, but only for so long. Our industry-leading Dynamic Write Acceleration technology solves this problem by using an adaptable pool of high speed, single-level cell flash memory for consistently fast performance that doesn't let up. Our engineers created RAIN technology to protect your data at the component level, similar to how RAID is used with multiple hard drives. This technology increases the security and protection of your data to a level that's rarely seen in consumer-class SSDs. Keep personal files and sensitive information secure from hackers and thieves with AES 256-bit encryption the same grade used by banks and hospitals. The Crucial MX200 meets or exceeds all industry encryption standards, including Microsoft eDrive, IEEE-1667, and TCG Opal 2.0. With Extreme Energy Efficiency technology, the Crucial MX200 is nearly 2x more energy efficient than a typical hard drive. When a photo or file gets corrupted, it often becomes unusable. Prevent this from happening in the first place with the Crucial MX200, which arms every storage component with four layers of Exclusive Data Defense. Adaptive Thermal Protection technology enables the Crucial MX200 to dynamically adjust storage component activity based on how you're using the drive, allowing your storage system to stay cool.
Show:
Login / Registration
укажите почту
введите пароль
Forgot password?
By clicking «#SUBMIT_NAME»,
you agree to our Privacy Policy
Loading data...
Subscribe to our newsletter
specify your contacts

By clicking «#SUBMIT_NAME»,
you agree to our Privacy Policy

You have successfully subscribed
Now you can receive newsletters